Product Overview
This product is suitable for the detection of tension during processing of wire and strip. Products using 128 × 64 LCD display, high brightness backlight design, clear display. Surface button design is simple and elegant, easy to operate. New product modeling, streamline handle design user-friendly handheld. Measurement results directly show the tension value and the maximum and minimum synchronization provider.
Overall Structure
Operating Instructions
Boot
Tension table by the side of the power switch can enter the power-on state.
Description of the function keys
"Clear": clear parts reset button. In the measured data, and when you press this key is cleared from a reset function.
"G / N": used as a "g / cow" unit conversions.
"Hold": the measured values were locked.
LCD Description
1: "Run" to the running state,
"Hold" for the locked state;
2: The maximum tension value;
3: The minimum tension value;
4: The maximum range of the tension table;
5: Power display;
6: Tension measurements;
7: Tension Table measurement accuracy;
8: backlight indicator;
9: buzzer indication.
  
(Figure 1) (Figure 2) (Figure 3)
Measurement Considerations
As shown below:
One, to try to make curved wire rack before measurement measured along the wire to maintain the level, press the "clear" button clears; measurement process should try to maintain this holding table
Gesture (Figure 1)
2, pressing and releasing the guide wheel arm, the finger movements to the appropriate soft (Figure 2)
3, due to the tension of the wire measured value fluctuations, in order to more easily reading, you can use the "hold" button to lock the data (table after leaving the wire can be read),
But in the absence of the shutdown and then the next measurement should then click the "hold" button to release the lock (Figure 3)
Precautions
1, the tension table applies only to the wire and strip tension measurement;
2, before each use must be above "Measurement Considerations" in the method (1) of the requested operation, in order to ensure the accuracy of measurements;
3, the tension in the user table does not take the initiative to shut down and in a static state, 30 seconds after the tension of the table will automatically turn off the backlight, five minutes after the tension of the table will automatically shut
Machine, in order to save electricity;
4, the tension placed on the table when not in use indoors in a cool, dry place without excessive vibration;
5, measured when measuring the load table range, will prompt "Error" message on the screen. You should immediately reduce the load of the load to avoid damaging the tension table.
6, do not hand or other hard objects directly touch sensor located in the middle of the tension wheel to reduce the tension table damage, affecting the measurement accuracy;
7, tension table built-6V / 650mAH high-performance nickel-metal hydride rechargeable batteries, do not apply to other types of battery replacement. The same machine is equipped with a smart charger to charge this tension table
Electricity. Smart charger with the red light is charging, when the red light into green light when the battery is fully charged. Make sure that each charge are
Can then stop at the green light to try to extend the battery life. When they find a smart charger LED indicator light flashes, indicating that the battery is in a bad state,
Please Depot replacement. As long as the smart charger when charging power output plug into the socket at the bottom of the handle tension table, but you can see the red light indicator handle.
Range setting
|
Type |
Range |
Accuracy |
|
JDK-01-500 |
0-500g |
1g |
|
JDK-01-1000 |
0-1000g |
2g | | 
